Lube Automatic intermittent gear pump PM Spain

Enapart, with a presence in 14 countries, sources products from around the world to offer you the best possible prices as a local reseller in the Spain .  To acquire the best quotation for your desired product, kindly contact us through e-mail or our contact form.

page

 

 

Directions for use

The 1PM type Pump is an air-driven pump that reciprocates the piston by air pressure, so a 3-way switching valve is required to turn the air on and off. The 2PM pump is designed to generate a discharge pressure of 0.5MPa with an air input pressure of 0.1MPa (Pump ratio 1: 5). However, since the operating pressure of the metering valve is 1.2MPa or more, the air input pressure must be set to maintain 0.35 to 0.5MPa. Also, adjust the air input pressure not to be 0.45 MPa or less even if oil (liquid) jumps from the jet nozzle at the tip. (3) The viscosity range of the oil (liquid) used is 10 mm2 / s to 100 mm2 / s (viscosity when used). If the viscosity is extremely high, it is yes that repeated discharge can not be performed in a short cycle (intermittent time). Aluminum material (PumpBody) and NBR rubber material (O-ring) are used for 4PM type Pump. When using special oil (liquid), please contact our Global Center.
 

PM-8S-L-3LF

PM-8S-L-30LF

PM-8S-L-40LF

PM-8S-L-80LF

PM-8S-L-3RF

PM-8S-L-30RF

PM-8S-L-40RF

PM-8S-L-80RF

PM-8S-L-3LB

PM-8S-L-30LB

PM-8S-L-40LB

PM-8S-L-80LB

PM-8S-L-3RB

PM-8S-L-30RB

PM-8S-L-40RB

PM-8S-L-80RB