Pressure sensors
Enapart, with a presence in 14 countries, sources products from around the world to offer you the best possible prices as a local reseller in the Spain . To acquire the best quotation for your desired product, kindly contact us through e-mail or our contact form.
In the inline pressure sensor (IPS), the applied pressure of liquid or gaseous media is recorded via a ceramic pressure measuring cell and converted into an electrical signal. In combination with ELSA push-in fittings made of PPSU, they are ideal for use in the food industry. Various materials are available for the seal.
Inline pressure sensor for measuring pressure of liquid and gaseous
media. The ceramic pressure measuring cell combined with the proven ELSA
push-in connector made from PPSU is mainly used in the food industries.
Other features:
• minimal dead space
• temperature-compensated
elavation electronics
• materials and constructional design
especially optimised for food applications
Variations / options:
• other tube connections
• other material for seal
• other pressure range
GENERAL CHARACTERISTICS
Constructional design : Ceramic pressure measuring cell
Product name : Inline pressure sensor
Product type : IPS-V36
Nominal diameter : DN 2.5 up to DN 6
Connection : ELSA plug fittings for pipe/tube OD 4 to OD 8
Ambient temperature : 0 °C to +60 °C
Medium temperature : 0 °C to +140 °C
Body material : PPSU (KTW approved, NSF certified)
Measuring cell material : Al2O3
O-ring material : FKM / EPDM
Mounting method : by spring clip, internal width Ø18-22 mm (not included in scope of supply)
Mounting position : Preferably upright
Approval : NSF/ANSI 169
PNEUMATIC - HYDRAULIC
Nominal pressure : up to PN 16 in accordance with the specification table
Pressure range : 0 bar (Vacuum: -0,8 bar) up to allowable operating pressure OP in accordance with the specification table
Flow rate : Kv-value in accordance with the specification table
Medium : Gases or liquids which do not corrode the materials specified
ELECTRIC
Supply voltage : +5 V bis +36 V DC
Voltage tolerance : ±10 %
Output voltage : +0,5 V bis +4,5 V DC (ratiometric) (0 V to +5 V DC, 0 V to +10 V DC DC on request)
Electrical connection : 0.75 m 3-pole screened cable (LiYCY 3 x AWG 26), strand ends pre-tinned.
Protection class : IP65
ACCURACY
Total error : ±1.5 % FS
Temperature error zero point : <±0.02 % FS/K
Temperature margin of error : -0.012 % FS/K
Response time : <2 ms
Caution! PPSU should not be used in contact with aromatic hydrocarbons, oxidising acids, acetone, chlorinated hydrocarbons, ethers or ketones! Also, PPSU should not be
placed directly in contact with anaerobic adhesives!
